Drawer Pulls

I had some nice antique brass drawer pulls that look quite nice against the deep red of the bubinga but I had to forgo them as the screws were an odd length and I couldn’t find a replacement. I know just but new screws but they are inch and I am in a country that uses metric so it was too much searching for something so small. I ended up making them, which is just as easy.

For this I choose some birds-eye maple I had and route a groove with a round-over bit on all four side.

After the groove has been routed I cut a bevel on the top and put in some 4mm wood anchors.

Attached.

The final appearance.

Alex

About Alex

Love making sawdust and turning wood into objects of practical beauty.
This entry was posted in Fusako's Table. Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>